Pulnix TS-9720EN Series Manuale delle Istruzioni Scaricare il pdf (Pagina 42)

Page 34

Connectors and Cables

TS-9720EN Series Progressive Scan Shutter Cameras

5.3 Power Supplies and Power Cable Setup

5.3.1 Power Supplies

The TS-9720EN requires 12V DC power that is obtained through the 12-pin connector located on the

rear panel of the camera. JAI PULNiX recommends the following power supplies:

PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply with

US plug

PD-12UUP 100-240V AC 1.2A universal voltage power supply with US plug

and 12-pin connector

PD-12UE 100-240V AC/12V DC 1.2A universal power supply with European plug

PD-12UEP 100-240V AC/12V DC 1.2A universal power supply with European plug and

12-pin connector

If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power

supplies are available with the 12-pin mating connector already attached to the leads from the power

supply. The PD-12UU or PD-12UE power supply can be connected to the JAI PULNiX power cable

either directly or via a terminal strip.

When wiring the PD-12UU power supply directly, please note the following:

• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and

shorting.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

5.3.2 JAI PULNiX Power Cables

If you are using JAI PULNiX power cables such as the 12P-02S, please refer to the 12-pin connector

pin-out diagram in “12-Pin Connector” on page 32. The cable pin-out diagram is shown in Figure 14

below. The color-coded leads use Gray for Ground and Yellow for +12V.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 62 63

Nessun commento

Pulnix TS-9720EN Series Manuale delle Istruzioni Pagina 42