Pulnix TS-9720EN Series Manuale delle Istruzioni Scaricare il pdf (Pagina 11)

TS-9720EN Series Progressive Scan Shutter Cameras

Page 3

Getting Started

2 Getting Started

2.1 Required Equipment

FIGURE 1. Typical Equipment Setup

• PD-12 power supply

• Cat5e/6 Ethernet cable

• 10/100/1 G Ethernet switch

• Debug-232 serial/power cable (JAI PULNiX part number 31013219)

2.2 Network Settings

2.2.1 Default Network Settings for the TS-9720EN Camera

The factory default network setting for the TS-9720EN is the following:

IP address : 10.0.0.65

Subnet mask : 255.255.255.0

Default gateway : 255.255.255.255 (disabled)

You must set up your computer network properly in order to allow it to communicate with the

TS-9720EN camera. It is very important to that your PC NOT be assigned the same IP address as the

camera. If you need to change the IP address, follow the instructions in Section 2.2.2 on page 4.

EN1* EN2* EN3*

Cat5e/6 Ethernet cable

Ethernet switch

Each camera requires a PD-12 12-V power supply.

For details, please see “Power Supplies and Cable Setup.”

1P1 1P2 1P2

EN setup software

Cat5e/6 Ethernet cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

Nessun commento

Pulnix TS-9720EN Series Manuale delle Istruzioni Pagina 11