Pulnix TM-250 Manuale delle Istruzioni Scaricare il pdf (Pagina 11)

Page 5

Installation

TM-250 Miniature CCD Camera

TABLE 1. 12-Pin Connector Conﬁguration

2.2.2 Power Supply and Power Cable

2.2.2 (a) Power Supplies

PULNiX recommends the following power supplies:

K25-12V 110V AC/12V DC 2.1A power supply (OEM type)

K50-12V 110V AC/12V DC 4.2A power supply (OEM type)

PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply

PD-12UP PD-12UU with12-pin connector US plug

PD-12UE PD-12UU European plug

PD-12UEP PD-12UU with 12-pin connector European plug

If you are providing power through the 12-pin connector, the PD-12UUP power supply is available with

the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU power

supply can be connected to the PULNiX power cable via a terminal strip or directly.

When wiring the PD-12 power supply directly, please note the following:

• The lead ends must be twisted together and tin soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

2.2.2 (b) PULNiX Power Cables

If you are using PULNiX power cables, such as the 12P-02S, please refer to the appropriate pin-out

diagram. The color coded leads use Gray for Ground and Yellow for +12V DC.

Pin Description Pin Description

1 GND 7 VD Input

2 +12V DC 8 GND

3 GND 9 HD Input

4 Video Out 10 N/C

5 GND 11 N/C

6 VINIT/TRIG Input 12 GND

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Nessun commento

Pulnix TM-250 Manuale delle Istruzioni Pagina 11